Manufacturer of Electronic Welding Machinery Controls

Fuel prices eating up your profits?
We offer a solution to your problem!
Read more information here.

In June of 2002 the Pipeliner machine board was changed to accommodate a much greater variety of welding machines.  This change also greatly simplified both installation and troubleshooting of the unit.

Pipeliner hand control units have not been modified and are still interchangeable among all Pipeliner remote control systems.

The Pipeliner-I and Pipeliner-II are discontinued.  The Pipeliner-I features are now available as an accessory and the Pipeliner-II has been incorporated into the standard Pipeliner.

The following pages are from the original operational and installation directions so that those owning our older models will have technical data available in the event that repairs, troubleshooting or reinstallation of older components are necessary.

DO NOT USE THE FOLLOWING PAGES FOR THE NEWER MODEL PIPELINER!

They are for reference and support of older models only.

Some files are in Acrobat PDF format and must be read with Acrobat Reader.  If you do not have the reader installed please download a free copy of it by clicking on the PDF reader icon.

The links on this page are to assist in troubleshooting problems with our line of Pipeliner Controllers.

If problems are encountered in installation or in general operation of the controller use the troubleshooting guides below.

Original installation instructions.

Use of the Mini thumb control.

Troubleshooting installation on a SA-200, Classic-I or any other SA series with DC exciter.

Troubleshooting installation on a SA-250, Classic-II, Classic-III or Classic 300D machine.

Testing the hand control on the bench.

Testing the machine circuit board on the bench.